Jump to content

buzzman

Members
  • Content Count

    60
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. thank you all. Did your boats rev at normal RPMs on neutral like mine and not rev over 3000rpm once in gear?
  2. Thank you again. Did you have to replace the entire pump or just the high pressure pump? Also, did your boat rev normal rpm while in neutral as mine does? Thanks! 

  3. Thank you both. Is it difficult to replace the pump as I see the part online? Can I do it myself?
  4. Boat won't go over 3000 RPM lose of power and shakes a bit. Could it be the spark plugs. 2006 signature 276 Volvo Penta 8.1 gi-g please help! Thanks
  5. Buzz, you have any Atlantic Blue 9219 by chance?

  6. Thank you all. Appreciate the quick feedback. I will let you know how it goes.
  7. Hello- my drain plug is seized and I will order a new assembly from Joe at Cecil. Any advice how to remove and replace? What type of sealant and do I drill new holes? This job has me a bit nervous. Thank you
  8. Hello I have a 2006 Sig 276 and have yet to replace the three bellows. Is it necessary to replace if they look to be in god shape. If I replace them can I do that without removing the volvo penta DPS stern drive? Thank you!
  9. Did you figure it out? Same issue just started with mine. Any suggestions?
  10. Does anyone know how I can tighten this bow rail as I am not sure how to access where the bow rail joins the side of boat? Any help would be appreciated. Thank you
  11. Hello - I went to grease the gimbal today and I pulled the tube and zerk fitting out of the drive. Do you know the part number for a new tube and zero fitting as the zero is stripped. Any advice would be great! Thank you
  12. Hello I will be removing my props this weekend and changing the oil in the drive trough the drian plug. Do you know what oil part number I use and how many quarts to order? Also, do you pump this in through the drainplug untill it reaches the dipstick? How do you know if it is filled properly. Thank you!
  13. Hello Went to winterize boat today and drain port side of engine block through the raw water drain. There is a wire attached to the drain so I am not sure how to drain it as easy as the starboard side which was a brass fitting. Any suggestions please?
  14. Hello Went to winterize boat today and drain port side of engine block through the raw water drain. There is a wire attached to the drain so I am not sure how to drain it as easy as the starboard side which was a brass fitting. Any suggestions please?
×
×
  • Create New...