Mark madden

Members
  • Content count

    32
  • Joined

  • Last visited

About Mark madden

  • Birthday 09/17/1957

Profile Information

  • Gender
    Male
  • Location
    Astor Florida
  • Interests
    Boating and motorcycle riding

Recent Profile Visitors

598 profile views
  1. BOW AND STERN
  2. BOW AND STERN
  3. We were anchored Saturday in the hot Florida weather so I started my genny to run the a/c just before we were ready to sleep my c/o detector went off. I was not running the blower but now I believe I need to run it especially when anchored?
  4. I WOULD LIKE MY HELM SEAT TO BE RAISED UP ABOUT 8 TO 10 INCHES HAS ANYONE DONE THIS AND DO YOU HAVE ANY SUGGESTIONS I THINK IT MIGHT HAVE TO BE CUSTOM MADE?
  5. I HAVE A 2001 CHAPARRAL SIG 350 AND I NEED TO REPLACE THE A/C METER ON THE 120 VOLT FOR THE SHORE LINE 1 DOES ANY ONE KNOW WHERE I CAN GET ONE?
  6. "AWESOMEST" I named our Sig 350 for my wife of 37 years because she is the Awsesomest lady I know.
  7. My engine hatch on my Sig 350 opened but would not go down as it appeared to be no power, is there a breaker or fuse for the hatch motor that any one knows about?
  8. Not making noise but I did not think about a breaker where might it be?
  9. So would that mean an air leak since no water is being flushed?
  10. During the sea trial inspection of my 2001 Signature 350 the inspector noted that the Balance gauge synchronizer was inoperable, can anyone explain what this gauge is for and should I replace it?
  11. During the sea trial inspection of my 2001 Signature 350 the inspector noted that the Vacuflush system would cycle with no use on the system, does anyone know what could be the cause for this?
  12. My engine hatch on my 2001 Sig 350 lifted up but then would not go back down how do I test the motor or console switch?
  13. My engine hatch on my 2001 Sig 350 lifted up but then would not go back down how do I test the motor or console switch?
  14. Well I found out that my aft bilge pump works fine it is a Sahara 1100 with a built in automatic float so that explains why the original float switch is still there with the wires cut. My next thing I tried to check on was the forward bilge pump but I can't find it, can anyone tell me where it would be located. The only thing I find forward is The sump pump containment system.
  15. Does anyone know where the forward bilge pump is located on a Sig 350 2001 ?