Jump to content

chris D

  • Content count

  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I want to replace my old Atwood 1250 with external float with a new Rule-Mate integrated unit. The problem is that the old Float has two brown wires going into a Brown and Brown Orange plug, While the Pum has a Black and Brown. The pictures shows it below. I think its Pump Black to Boat Yellow Pump Brown to BOAT or FLOAT BROWN? Float Brown /White to BOAT Brown/Orange
  2. chris D

    2004 SSI 260 bilge pump

    The original Atwood 1250 float sits up on a platform in my boat (same exact as yours). Compounding that is the pump impeller sits a good half inch off hull bottom. I just bought a new RULE-MATE 1100,,however it has 3 wires, not 4. Thats in another post.
  3. chris D

    For Sale and Wanted Sections

    I should be more specific, not boats, but parts. Used, NOS, and wanted. Not talking current product offerings, and not to conflict withproduct or offering.
  4. chris D

    Bow Filler for 04 260 SSI

    Anyone here looking to sell theirs?
  5. Would it no be of advantage to have both a For Sale and wanted area of this forum?
  6. chris D

    Bow Filler for 04 260 SSI

    I am looking on where to get a bow filler and rods for a 260ssi. The seller said it came with it, but it turns out is the Stern filler cushions and rods. Any aftermarket or good source for them? Checked ebay and craigslist to no avail. There is a set on ebay for Sunesta, not sure they would fit.
  7. chris D

    04 260ssi side scupper/hull flapper correct size

    Perfect! Thank you!
  8. Just purchased an 04 with 100 hours on it that resided in a Boatel. The side scuppers are long gone. My calipers best measurement is 1 to 1-1/8 inch across, yet I cannot find a replacement that size. Thanks in advance.