Jump to content

EDLS

Members
  • Content Count

    7
  • Joined

  • Last visited

  1. I had added a comment on the picture, looks like it may not be showing up on your end. If you look at the top cover you will see a hand latch (White with a center whole and a hand unlock lever) , when you lower the engine cover the latch is to make contact with something on the bottom. I would guess it's the male portion of the latch, however, they forgot to install it at the factory. currently the hood cover bounces around when boating.
  2. Got my S&F last week, 2 hrs on it. My advise...go back to the dealer and get your money back. ASAP! These boats are a nightmare, quality is garbage. When I picked up the boat it had the following issues: 1-No latch on the motor cover, they forgot to install it at manufacturing...unreal! 2-Poor workmanship on the gel coat, defects and chips all over the place. Poor finish 3-Cables on the passenger side hanging after I trailered for 30 minutes, 4- Garbage left on the boat from factory 5-Mercury engine stalls when in idle. 6- And this is the worst offender of all... You cannot exceed 35miles on the boat or you will loose your rear cushions. Lost my cushions 20 minutes into my break in run...and forget about trailering with the cushions on, that not happening. Advised by the dealer. walk away... trust me. I have pictures but can’t load as they are 2 large.
  3. EDLS

    Velocity Tower

    Hello Everyone, New to the forum, new to Chaparral...Exited to be the owner of a new 2021 21' SSI Fish and Ski. Just got my boat. However, i did make one mistake when ordering...I did not order the Velocity tower and now i need one, kids started to wake-board and I would prefer to have a tower vs the i tow. Does anyone know if a velocity tower can be installed on an SSI F&S after delivery? I've already contacted my local Chaparral dealer and they are unsure, waiting on a response from HQ. Any insight is greatly appreciated. Thanks
×
×
  • Create New...