Search the Community
Showing results for tags 'remove'.
Found 2 results
I have just purchased a 2015 257 SSX with a hard top tower. The stern navigation light sits on top of the tower. This limits the headroom I have on my lift to raise the boat. Is there a way to easily remove the light in order to raise the boat higher?
I have an unusual challenge : I have a 2000 200 SSE [purchased used] I have already purchased a new hub that matches an aftermarket steering wheel, however when I went to make the simple swap out, I found that the center steering nut will not loosen, how might I remove the hub in this case. Note that the new steering wheel does not match the bolt size of the original hub. Removing the steering wheel itself is simple except one of the six original hex screws was seized, this is not really supposed to be a problem since I have a replacement hub... as far as the old hub, I want to put a little pressure on the hub outward with a puller and then try a removal of the seemingly stripped nylon jam nut but cant get enough movement up/outward on the [or what i assume to be the] spline shaft to nudge or encourage the nut to loosen. The center bolt on the steering hub just spins, i.e. will not loosen [note: nut either by design [i doubt it] or by previous error the nut will not remove the normal way]. It seems to have a nylon insert jam lock nut, the threads seem to be stripped as the nut will not loosen with a 3/4" socket and ratchet set.